Table Of Contentइंटरनेट मानक
Disclosure to Promote the Right To Information
Whereas the Parliament of India has set out to provide a practical regime of right to
information for citizens to secure access to information under the control of public authorities,
in order to promote transparency and accountability in the working of every public authority,
and whereas the attached publication of the Bureau of Indian Standards is of particular interest
to the public, particularly disadvantaged communities and those engaged in the pursuit of
education and knowledge, the attached public safety standard is made available to promote the
timely dissemination of this information in an accurate manner to the public.
“जान1 का अ+धकार, जी1 का अ+धकार” “प0रा1 को छोड न’ 5 तरफ”
Mazdoor Kisan Shakti Sangathan Jawaharlal Nehru
“The Right to Information, The Right to Live” “Step Out From the Old to the New”
IS 15606 (2005): Ethion + Cypermethrin, EC [FAD 1:
Pesticides and Pesticides Residue Analysis]
“!ान $ एक न’ भारत का +नम-ण”
Satyanarayan Gangaram Pitroda
““IInnvveenntt aa NNeeww IInnddiiaa UUssiinngg KKnnoowwlleeddggee””
“!ान एक ऐसा खजाना > जो कभी च0राया नहB जा सकता हहहहै””ै”
Bhartṛhari—Nītiśatakam
“Knowledge is such a treasure which cannot be stolen”
1S 15606:2005
W?7fm WmF
—
@kih + w@kRT l“”@
Indian Standard
ETHION + CYPERMETHRIN, EC — SPECIFICATION
ICS 65.100.10
. .
0 BIS2005
BUREAU OF INDIAN STANDARDS
MANAK BHAVAN, 9 B AHADUR SHAH ZAFAR MARG
NEW DELHI 110002
November 2005 Price Group 1
Pesticides and Pesticides Residue Analysis Sectional Committee, FAD I
FOREWORD
This Indian Standard was adopted by the Bureau ot”lndian Standards, after the draft finalized by the Pesticides
and Pesticides Residue Analysis Sectional Committee had been approved by the .Food and Agriculture
Division Council,
F,thion+Cypermethrin, EC, isused asan insecticide.
The material isgenerally manufactured tocontain40percent (m/m )ofethion and5percent (m/m )ofcypermethrin.
[n preparation of this standard, due consideration has been given to the provisions of the Insecticides Act,
1968 and the Rules framed thereunder. However, this standard is subject to the restrictions imposed under
the Insecticides Act and Rules, wherever applicable.
For the purpose of deciding whether a particular requirement of this standard is complied with the final
value, observed or calculated, expressing the result of a test or analysis, shall be rounded off in accordance
with IS2: 1960 ‘Rules for rounding off numerical values (revised )’. The number of significant places retained
in the rounded off value should be the same as that of the specified value inthis standard,
Indian Standard
ETHION + CYPERMETHRIN, EC — SPECIFICATION
1 SCOPE It shall readily form an emulsion on dilution with
water, suitable for spray.
Thisstandard prescribes therequirementsandmethods
ofsampling and test for Ethion +Cypermethrin, EC. 3.2.2 Cold Test
2 REFERENCES No turbidity or separation of”solid and/or oily
matter or both shall occur when the material is
The following standards contain provisions which
subjected to cold test at 10°C as prescribed in 13.1
through reference in this text, constitute provisions
ofIS 6940 or anyother lower temperature asagreed
of this standard. At the time of publication, the
to between the purchaser and the supplier.
editions indicated were valid, All standards are
subject to revision and parties to agreements based 3.2.3 Flash Point (Abel)
on this standard are encouraged to investigate the
When determined by the method prescribed
possibility of applying the most recent editions of
in IS 1448 [ P :20 ], the flash point of the material
the standards indicated below:
shall beabove 24.5°C.
IS No. Title
3.2.4 Emulsion Stability
1070:1992 Reagent grade water ( fhifid
Any separation including creaming at the top and
revision )
sedimental ion at the bottom of 100 ml of emulsion
694(I:1982 Methods of test for pesticides and prepared instandard hardwaterwith2mlconcentrate,
their formulations (jlrst revision) shall not exceed 2.0 ml when tested by the method
prescribed in13.3ofIS6940.
1448 Methods of test for petroleum and
[P:20] :1998 itsproducts: [P: 20] Determination 3.3 Chemical
of flash point by Abel apparatus
3.3.1 Ethion Content
(second r-evisian )
When determined by the method prescribed in
8190 Requirement for packing of
Annex A of IS 10369, the observed ethion content
(Part 2): 1988 pesticides: Part2Liquid pesticides
percent ( m/m ) of any of the samples shall not
(second revision)
differ from the declared nominal value bymore than
10627:1983 Methods of sam pling for pesticidal the percent tolerance limits indicated in3.3.2.1,
formulations
3.3.2 Cypermethrin Content
10369:1982 Ethion, technical
3.3.2.1 When determined bythe method prescribed
12015:1987 Cypermethrin, technical inAnnex Aof 1S 12015, the observed cypermethrin
content, percent ( m/m ) of any of the samples shall
3 REQUIREMENTS
not differ from the-declared nominal value by more
3.1 Constituents than the percent tolerance limits indicated below:
3.1.1 The material shall consist of ethion technical Nominal value, Percent Tolerance, Percent
and cypermethrin technical dissolved in suitable upto 9 +10]
solvent(s). together with emulsi&ing agent(s), and
-5
with or without stabilizers(s) and/or coupler(s). of the
Above 9and below 50 &5 nominal
3.1.2 Ethion technical and cypermethrin technical
value
employed in the formulation of this material shall 50and above +5
.,[
conform to IS 10369and IS 12015,respectively. –3 J
3.2 Physical 3.3.2.2 The actual value ofethion and cypermethrin
content in the formulations shall be calculated
3.2.1 Description
to the second decimal place and then rounded off
The material shall be clear, homogeneous, stab le to the first decimal place before applying the
liquid, free from sediment and/or suspended matter. tolerance given in3,3.2.1.
IS 15606:2005
3.3.3 Acidity 5.2.1 The use of the Standard Mark is governed
by the provisions of the Bureau of Indian
When tested by the method prescribed in 13.5 of
Standards Act, 1986and the Rules and Regulations
IS 6940, the acidity ( as H2SOd) of the material
made thereunder. The details of conditions under
shall not be more than 0.5 percent by mass.
which the licence for the use of the Standard Mark
4 PACKING may be granted to manufacturers or~roducers may
beobtained from the Bureau of Indian Standards.
The material shall be packed intin plate containers
suitably and properly lacquered from inside, 6 SAMPLING
aluminium containers or PET containers. The
When freshly manufactured material in bulk
containers shall also meet the general requirements
quantity and/or the retail pack of the formulated
given in1S8190 (.Part2 ).
product is/are offered for inspection, representative
5 MARKING sample of the material shall be drawn and tested as
prescribed inIS 10627, and iftested within 90 days
5.1 The containers shall bear legibly and indelibly
of its date of manufacture, the criteria for
the following information in addition to any other
conformity shall be the contents inpercent ( m/m ),
information as is necessary under the Insecticides shallnotbelessthanthedeclared nominal value. The
Aet, 1968‘andRules framed thereunder: upper limit forconformity shall bethe same asthose
given in3.3.2.1.
a) Name ofthe material;
b) Name and address of the manufacturer; When the material is offered for inspection after
c) Batch number; 90 days of its manufacture, sampling shall be done
as prescribed in IS 10627, however, the criteria for
d) Date of manufacture;
conformity ofthe material, when tested, shall bethe
e) Date ofexpiry; -limitsoftolerances, as applicable over the declared
f) Net mass of contents; nominal value and given under 3.3.2.1.
g) Ethion + cypermethrin content, percent 7 TESTS
(m/m);
7.1 Tests shall be carried out by appropriate
h) The cautionary notice as worded in
methodsreferred to in3.2.2to3.2.4 and3.3.1to3.3.3.
Insecticides Act, 1968 and Rules framed
thereunder; and
7.2 Quality of Reagents
J) Any other information required under the
Unless specified otherwise, pure chemicals and
Standards of Weights “and Measures
reagent grade water (see IS 1070) shallbeemployed
(Packaged Commodities) Rules, 1977.
in tests.
5.2 BIS Certification Marking
NOTE— ‘Purechemicals’ shall mean chemicals that
The product may also be marked with the Standard do not contain impurities, which affect the results of
Mark. analysis,
2
Bureau of Indian Standards
BIS is a statutory institution established under the Bureau of lndian ,$~andard,s ~ct, 1986 to promote
harmonious development of the activities of standardization, marking and quality certification of goods and
attending to connected matters in the country.
Copyright
BIS has the copyright of all its publications. No part of these publications may be reproduced in any form
without the prior permission inwriting of BIS. This does not preclude the free use, inthe course of implementing
the standard, of necessary details, such as symbols and sizes, type or grade designations. Enquiries relating
to copyright be addressed to the Director (Publications), BIS.
Review of Indian Standards
Amendments are issued to standards asthe need arises on the basis of comments. Standards are also reviewed
periodically; astandard along with amendments isreaffirmed when such review indicates that no changesare
needed; ifthe review indicates that changes are needed, it istaken, up for revision. Users of Indian Standards
should ascertain that they are in possession of the latest amendments or edition by referring to the latest issue
of ‘BIS Catalogue’ and ‘Standards :Monthly Additions’.
This Indian Standard has been developed from Doc :No. FAD 1( 1350).
Amendments Issued Since Publicaticm
Amend No. Date of Issue Text Affected
. .
BUREAU OF INDIAN STANDARDS
Headquarters:
Manak-Bhavan, 9Bahadur Shah Zafar Marg, New Delhi 110002
Telephones: 23230131,23233375,2323 9402 Website: www.bis.org. in
Regional Offices: Telephones
Central : Manak Bhavan, 9 Bahadur Shah Zafar Marg 23237617
NEW DELHI 110002 { 23233841
Eastern : 1/14 C. I.T. Scheme VII M, V. 1.P. Road, Kankurgachi 23378499,2 J378~l
KOLKATA 700054 { 23378626,23379120
Northern: SCO 335-336, Sector 34-A, CHANDIGARH 160022 “2603843
{ 260.9285
Southern: C. I.T. Campus, IV Cross Road, CHENNAI 600113 22541216,22541442
{ 2254.2519,22542315
Western : Manakalaya, E9 MIDC, Marol, Andheri (East) f 28329295,28327858
MuMBAi400 093 ‘ ‘ ~ 28327891,28327892
Branches: AHMEDABAD. BANGALORE. BHOPAL. BHUBANESHWAR. COIMBATORE.
FARIDABAD. GHAZIABAD. GUWAHATI. HY.DERABAD. JAIPUR. KANPUR.
LUCKNOW. NAGPUR. NALAGARH. PATNA. PUNE. RAJKOr. THIRUVANANTHAPURAM.
VISAKHAPATNAM . —
Printedal New India Printing Press,Khmja, India
